Usage Method of Power Pump
Release Time:
May 16,2026
Usage Method of Power Pump
I. Preparations Before Use
Place it stably on a solid surface, with an inclination not exceeding 15°
Fill the pump with sufficient water to draw in water, drain all air
Add mixed fuel (for two-stroke engines) / pure gasoline (for four-stroke engines), and add engine oil
Secure the inlet and outlet water pipes, place the filter bottom valve underwater, and ensure no air leakage
Check that the screws, oil pipes, throttle, and ignition switch are in good condition
II. Startup Steps
Close the choke valve, open the fuel switch
Set the throttle to the medium position, pull the start handle to start
If the start is successful, slowly open the choke valve, preheat at idle speed for 1 minute
Gradually increase the throttle, start normal water pumping
III. Normal Use
It is necessary to install a filter screen for the inlet to prevent sand and stones from blocking the pump
Do not operate at high speed for a long time without load
Do not allow the pump to idle without water for more than 1 minute, as it may easily burn the impeller
Do not bend or flatten the water pipe to ensure smooth water discharge
When transporting water over a long distance, try to minimize the number of bends and increase the water volume
IV. Shutdown Method
Reduce the throttle slightly, run at idle speed for half a minute
Turn off the ignition switch to stop
Turn off the fuel switch
V. After Use Maintenance
Drain the residual water in the pump body and water pipes
Clean the inlet filter screen of debris and sand
Dry the oil stains and water marks on the body
If not used for a long time, empty the fuel in the fuel tank and store it in a dry place
VI. Common Precautions
Do not start and idle without water
Do not pump mud, sewage, or dirty water containing debris
If the inlet and outlet water pipes leak, no water will be discharged
New machines should be run under low load for a while before full load operation
Related News