Instructions for use and precautions of blower

Instructions for use and precautions of blower

1. Pre-Use Inspection

1.1. Check if the spark plug and all connection points are loose.

1.2. Check if the spark plug gap is between 0.6 and 0.7 mm.

1.3. Check if the air filter is dirty. If so, clean or replace it.

1.4. Check if the cooling air passage is unobstructed.

1.5. Check if the pipeline connections are in place.

1.6. Pull the starter 2 to 3 times to check if there are any abnormalities in the machine.

2. Filling Fuel

2.1. Use 90# gasoline and two-stroke engine oil in a certain proportion.

2.2. Add it to the fuel tank when the machine is off.

3. Cold Start

3.1. Pull the choke lever out and place it in the "closed" position.

3.2. Place the throttle control handle at the lowest position.

3.3. Press the manual fuel pump several times until oil flows out of the return oil pipe.

3.4. After the gasoline engine starts, slowly push the choke lever to the "open" position. Let the gasoline engine run at low speed for 2 to 3 minutes before performing the hair-drying operation.

4. Hot Start

4.1. If the machine is in a warm-up state, there is no need to place the choke lever in the "closed" position or press the fuel pump. Just gently pull the starter 2 to 3 times to allow the gasoline engine to intake fuel, then quickly pull the starter to start the gasoline engine.

5. Shutting Down

5.1. Place the throttle control handle at the lowest position.

5.2. Press the red shutdown button on the handle to shut down the machine.

6. Safety Precautions

6.1. Operators must wear tight-fitting clothes to prevent being sucked into the machine and causing accidents.

6.2. People who are ill, mentally ill, drunk, or not well-rested, and those who have not received usage training are prohibited from operating.

6.3. Do not direct the air outlet at others during operation.

6.4. Do not smoke or use open flames near the machine. Refueling must be done when the machine is off and the body has cooled down. Keep away from open flames and heat sources during refueling. Wipe up any spilled oil after refueling and make sure the fuel tank cap is tightly closed.

6.5. The maximum fuel volume during refueling should be 3/4 of the fuel tank capacity. Do not fill the tank to the brim. Make sure the fuel tank cap is tightly closed after refueling.